欧莱斯氧化铝表面丝印油墨 1、 适用材质:金属、电镀、氧化铝、电解板、铝塑板、喷(烤)漆、喷塑、PA塑料尼龙、电木、玻璃钢、密胺等。 2、 产品特性:半光、免烘烤、耐酒精、耐冲压。 3、 稀释剂:本公司B-03稀释剂或783慢干稀释剂。 4、 固化剂:本产品为单组份油墨,如有特殊要求也可选择添加固化剂增加附着力及墨层抗性。 5、 油墨调配:充份搅拌後取所需用量进行调配使用,双组份油墨先按比例添加固化剂搅拌均匀,然後再添加稀释剂稀释到合适粘度进行印刷;添加固化剂後的油墨**过使用时限会产生粘稠胶化现象,请及时清洗网版,并弃用油墨,不可回收。 6、 网版及刮胶:适合80T-140T(200目-350目)聚脂网纱,聚氨脂PU油性刮胶。 7、 干燥条件及时间:本产品可以常温干燥,也可以烘烤快速干燥,建议干燥温度及时间为25℃/24小时,60℃/40分钟,80℃/30分钟,100℃/20分钟。Screen printing ink Application materials: metal, electroplating, alumina, electrolytic plate, aluminum plate, spray (baked) paint, spray, PA nylon plastic, bakelite, glass steel, melamine and other. 2, product characteristics: semi light, non baking, alcohol, resistance to stamping. 3, thinner: the c o mpany‘s B-03 thinner or 783 slow dry diluent. 4, curing agent: This product for single c o mponent ink, such as special requirements can also choose to add curing agent increased adhesion and ink layer resistance. 5, ink deployment: fully mixing after taking amount redeployment, t w o-c o mponent ink first ac c ording to the proportion of adding curing agent and stirring evenly, and then add the diluted with a diluent to the appropriate viscosity printing; add curing agent after the ink over the use of time will produce the phenomenon of viscous gel, please timely cleaning screen, and abandoned ink and can not be recovered. 6, screen and frictioning: for 80T-140T (200 -350 mesh) polyester mesh, polyurethane PU oily frictioning. 7, drying conditions and time: the product can be dry at room temperature, can also be baked fast drying, rec o mmended drying temperature and time of 25 /24 hours, 60 /40 minutes, 80 degrees /30 minutes, 100 degrees /20 minutes.